A Good Cause with theBlogFrog

Come interact with other readers of this blog and help The Children's Hospital at the same time! BlogFrog is sponsoring the "Give the Gift of Community" challenge to its members to inspire blog readers to connect with their peers in communities this holiday season. If this blog gets 20 new participants to start or reply to a community discussion, BlogFrog will donate $10 to The Children's Hospital, one of the top 10 hospitals in the country for kids and teens. Don't be shy, hop on over to my community and meet your fellow readers! Happy Holidays!

Comments

Holly said…

Thanks for this great post about BlogFrog's holiday challenge!

December 10, 2009 at 8:04 PM

How to get Urine/Sweat stains out of your Mattress

If you have kids you have pee stains I know it. If you don't lucky you or you are a liar and in denial. I have pee stains on more than one mattress. I also have sweat stains on pillows because well I sweat a.lot . It's a gift I know. I digress. Anyway I have tried many different ways to get urine/pee out of mattresses and I have been very unsuccessful so I did a google search and what do you know? Another mom had pee stains too. So I borrowed her recipe and it totally worked so I am sharing it with you. All you need are these few house-hold ingredients and a spray bottle. I bought a really expensive one (NOT) I used one I had for my kids hair. It worked great. You will need: 3 Tablespoons Baking Soda 8 ounces Hydrogen peroxide 1 drop dish soap Mix together well and use right away. My mom discovered that if it is not mixed well the baking soda will clog the sprayer. You also can't store this apparently it doesn't last in t...

Master Bedroom Makeover Board and Batten

I highly recommend a few items although you don't HAVE to have them it just makes this project go so much faster. I bought a pancake compressor with three nail guns included saved me on this project and a miter saw. I bought both from Home Depot and they didn't pay me to say that it is just where I happen to shop. I actually had this all measured out and went to Home Depot and they cut the mdf primed boards for me. However I later purchased the miter saw and was then able to cut things right here at my house. The nail gun I used is a 16 gauge gun that can shoot nails up to 3 inches. I used a 2.5 inch nail to cover the thickness of the board and wall. Ok so I recommend deciding how you want your boards spaced first and measure and mark on the wall where you want them. I tried to do every 16 inches because that is how far apart my studs were but then I realized my wall wasn't an even length and so I have some that look a li...

I heart Faces Week 47~ We heart tooshies!

I am trying this again. I never win but it is fun to enter and see everyone else's photos. Go on over to I Heart Faces to see more entries.

Rudy Family Rukus~Parenting tips and humor meet in one big "rukus"

Search This Blog